Siemens SIMATIC NET SCALANCE W720 Operating Instructions Manual page 26

Description of the device
3.6 Reset button
● Loading new firmware
If the "Load & Save" menu command of Web Based Management is unsuccessful, the
reset button can be used to load new firmware. This situation can occur if there is a
power outage during the normal firmware update. You will find further information in the
configuration manual in Downloading new firmware using TFTP without WBM and CLI
(Page 45).
● Resetting the device to the factory defaults
The device can be reset to the factory defaults during operation. You will find more
detailed information in the configuration manual in Resetting the device to factory defaults
(Page 44).
26
NOTICE
Previous settings
If you reset, all the changes you have made will be overwritten by factory defaults.{xe
"Reset device"}{xe "Factory defaults"}
NOTICE
Inadvertent reset
An inadvertent reset can cause disturbances and failures in the configured network with
further consequences.{xe "Reset device"}{xe "Factory defaults"}
Operating Instructions, 10/2019, C79000-G8976-C322-11
SCALANCE W760/W720