Removing Transportation Safety Bolts; Connecting Water Supply - Smeg WTE 11735 XCST User Manual

Table of Contents

Advertisement

4.4.3 Removing transportation safety bolts

1
Loose all transportation safety bolts with an appropriate wrench until they turn freely
(C).
2
Remove the transport safety bolts by turning them slightly.
3
Insert the plastic covers in the bag containing the user manual to the openings on the
rear panel. (P)
A
CAUTION:
Otherwise, the product will be damaged.
C
Keep the transportation safety bolts in a safe place to reuse when the product needs to be
moved again in the future.
Install the transport safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!

4.4.4 Connecting water supply

C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 10 MPa).
It is necessary to have 10 – 80 liters of water flowing from the fully open tap in 1 minute to
have your product run smoothly. Attach a pressure reducing valve if water pressure is higher.
If you are going to use the double water-inlet product as a single (cold) water-inlet unit,
you must install the supplied stopper to the hot water valve before operating the product.
(Applies for the products supplied together with a blind stopper group.)
A
CAUTION:
tap. In such a case the laundry will get damaged or the product will switch to protection
mode and will not operate.
CAUTION:
stains on your laundry.
Connect the special water supply hoses supplied with the product to the
water inlets on the product. Red hose (left) (max. 90 ºC) is for hot water
inlet, blue hose (right) (max. 25 ºC) is for cold water inlet.
Make sure that the hot and cold water taps are connected correctly when
the product is being installed. If connected incorrectly, your laundry will
come out hot at the end of the washing process and wear out.
13 / EN
Remove the transportation safety bolts before operating the product!
Models with a single water inlet should not be connected to the hot water
Do not use old or used water inlet hoses on the new product. It may cause
Washing Machine / User's Manual

Advertisement

Table of Contents
loading

Table of Contents