Removing Cover; Maintenance - Be Cool foldy Manual

EN
seat belt goes should be 1-22 centimetres above the
child's shoulder. Check that the belt is not twisted
and tighten the seatbelt by pulling the diagonal belt
upwards. Check that the lap belt is located as low
as possible, across the thighs and not around the
tummy.

3. REMOVING COVER

1 _ Step one Detach the female snap from male snap
of seat .
Remove the headrest cover: as shown in figure 2, pull
the cover out of car seat.
Remove the side wing cover: as shown in figure 3,
open the snaps on both sides
of backrest, then you can remove the fabric cover.
Remove cushion cover: as shown in figure 4, open
the snaps on handrail and
bottom, then remove the fabric cover
26

4. MAINTENANCE

Store the harness away and remove the padding.
Take the fabric cover off the headrest.
Unfasten the button and remove the fabric cover
from the lower part of the headrest.
To fit the fabric cover again, follow the same steps in
reverse order.
The safety lock is not working properly if the
following situations occur:
1) When you press the red button it opens slowly
2) It is not possible to insert the metal parts of the sa-
fety lock into the fastener or, when they are inserted
they automatically come loose again.
3) The safety button does not emit the safety click.
4) It is difficult to insert the metal parts into the
safety lock.
5) Excessive force is required to open the safety lock.