Table of Contents
Advertisement
Connecting the Display (Figure 11.1, 11.2)
Figure 11.2 needs to added for the USB port connection.
To setup this display, please refer to the following figure and procedures.
1.
Be sure the computer and monitor are turned off.
2.
Connect the DC power cord to the power connector; plug one end of the AC
power cord into the power adapter, and then the other end into an electrical
outlet (11.1
)
3. Connect the VGA signal cable from the display's VGA input connector to the
15-pin connector of your host computer and tighten the screws (11.1
4.
Connect the Audio-In cable from the audio input port of your display to the
Audio-out port of your computer (11.1
5.
For the PT1700M and the PT1701M, connect the RS-232 cable from the
RS-232 port of your display to the RS-232 port of your computer (11.1
6.
For the PT1700MU and the PT1701MU, connect the USB cable from the
USB port of your display to the USB port of your computer (11.2 ).
To ensure the LCD display works well with your computer, please configure
the display mode of your graphic card to make it less than or equal to 1280
x 1024 resolution and make sure the timing of the display mode is compat-
ible with the LCD display.
We have listed the "Video Modes" of this LCD display in the appendix for
your reference.
).
).
).
Advertisement
Table of Contents
