Operation; Lcd Status Screen; Dip Switch Settings - Phase Technology PERFECT PT007 Operation & Installation Manual

OPERATION

LCD Status Screen

When the unit is powered up, the screen will scroll through the operating parameters.
Figure 21 – Status Screen Figure 22 – "System Off" Status Screen

DIP Switch Settings

WARNING! Make sure the input power disconnect switch is in the OFF position
before opening the front cover to the unit. Opening the front cover with the switch in the ON
position exposes the user to the risk of electric shock.
WARNING: Risk of electric shock. Disconnect all incoming sources of power and wait
30 minutes before opening the front cover to change the DIP switch.
Factory-Installed
Jumper Wire
Main DIP
Switch Array
Figure 23 – Location of DIP Switches and Slide Switches
Table 28 – DIP Switch Settings
DIP Switch Function Default
Bypass AUX1 & AUX2 both ON
9 & 10 OFF/OFF
10 Enable VFD Mode note: SW9 must be OFF OFF
19 | Page
V4.1