Adjusting The Feet; Electrical Connection; Initial Use - Beko DFN05211W User Manual

Installation
C
Drainpipe must be connected
to the sewage system and it
should not be connected to any
surface water.

Adjusting the feet

If the door of the product cannot be closed
properly or if the product swings when you
push it slightly, then you need to adjust
the feet of the product. Adjust the feet of
the product as illustrated in the installation
manual supplied with the product.

Electrical connection

Connect the product to a grounded outlet
protected by a fuse complying with the
values in the "Technical specifications"
table. Our company shall not be liable for
any damages that will arise when the
product is used without grounding in
accordance with the local regulations.
Connection must comply with national
•
regulations.
Power cable plug must be within easy
•
reach after installation.
B
Unplug the product after the
washing programme is over.
Dishwasher / User's Manual
The voltage and allowed fuse or breaker
•
protection are specified in the "Technical
specifications" section. If the current
value of the fuse or breaker in the house
is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
The specified voltage must be equal to
•
your mains voltage.
Do not make connections via extension
•
cables or multi-plugs.
B
Damaged power cables must
be replaced by the Authorised
Service Agent.
B
If your dishwasher is equipped
with internal illumination, lamp
should only be replaced by the
Authorised Service Agent in
case of failures that may occur
on the lamp.
B
If the product has a failure, it
should not be operated unless
it is repaired by the Authorised
Service Agent! There is the risk
of electric shock!

Initial use

Before starting to use the product, make sure
that all preparations are made in accordance
with the instructions in sections "Important
safety instructions" and "Installation".
To prepare the product to do the dishes,
•
perform first operation in the shortest
programme with detergent while the
machine is empty. During the initial use,
fill the salt reservoir with 1 litre of water
prior to filling it with salt.
A
There might be a small amount
of water left in the product
after factory quality control
tests. This has no harm on the
product.
11 / 42 EN