Fuel Regulator Heater (20 And 26 Kw Models Only) - Kohler 26RCA Installation Manual

Note:
For Models 14RCA(L): If the generator set is equipped with a carburetor heater, obtain kit GM102228-S to replace the breather
tube, air cleaner spacer, and gaskets before installing the breather tube and oil heaters.
If the generator set is equipped with a carburetor heater, remove it before installing the breather tube and oil heaters.
The breather tube heating element wraps around the breather tube from the engine to the air cleaner.
Before installing the oil heater kit, drain the oil from the engine. Insert the oil heater near the oil drain valve using the coupling
provided in the kit. Connect the oil heater power cord to the breather tube heater cord.
Engine
Figure 54 Oil Heater, Typical
5.7.3

Fuel Regulator Heater (20 and 26 kW models only)

An optional fuel regulator heater is recommended for models 20RCA/L and 26RCA/L for improved cold starting in locations
where the ambient temperature drops below -18°C (0°F). The heater requires a continuous source of AC power.
Heater Part Number
Heater rating
Thermostat
Pad diameter
Cord length
Figure 55 Regulator Heater Kit Specifications
Figure 56 Fuel Regulator Heater Pad
58
14 kW Model
GM79142 GM118785
120 VAC, 60 W
4°C/13°C (40°F/55°F) Snap action
127 mm (5 in.)
914 mm (36 in.) 585 mm (23 in.)
20 kW Model
Engine
Pipe
Pipe coupling
Oil heater
Oil heater
20 and 26 kW Models
26 kW Model
TP-7091
GM110949
GM79142
4/23