Operating Procedure - Siemens LC97050 Instructions For Use Manual

Operating procedure

To activate the functions, simply tap the
buttons. If the buttons are pressed for too
long, no function is activated.
The most effective method of removing
vapours produced during cooking is to:
Switch the ventilator ON
as soon as you begin cooking.
Switch the ventilator OFF
a few minutes after you have finished
cooking.
Acoustic signal:
When a button is pressed, this is verified
by an acoustic signal.
Switching the fan ON
Press the + button.
Setting the required fan speed:
Press the + button.
The fan speed is increased by one step.
Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
Press the 0 button.
The displayed goes out shortly
{
afterwards.
Or:
Keep pressing the – button until the fan
switches off.
The displayed goes out shortly
{
afterwards.
Intensive setting:
Maximum power is obtained at the
intensive setting. It is only required for short
intervals.
Keep pressing the + button until a
appears in the display.
If the intensive setting is not cancelled by
hand, the fan will automatically switch
back to step after 10 minutes.
}
Fan follow-on:
Press the button.
!
The fan continues to run at step
10 minutes, and at the same time a dot
flashes in the display. After this period
the fan switches off automatically.
Lighting:
The light can be switched on at any
time, even though the fan is switched off.
Adjusting the brightness:
Hold down the button until the
a
desired brightness is obtained.
Push buttons block:
Before cleaning the cooker hood, it is
possible to block the push buttons keeping
pressed at the same time for 5 seconds the
0 and – push buttons.
The block is active for 10 minutes or till
when you press again at the same time the
0 and – push buttons.
ç
for
|
13