Table of Contents
Advertisement
Start Your Installation
Remove the Back Cover
Please follow these instructions to remove the cover on the back panel of the LCD so that
you can hookup the cables to associated connector.
1. Remove the stand back cover by pulling in the direction of the arrow.
2. Connect applicable cables to the appropriate connectors.
3.
Re-attach the stand back cover by pressing fi rmly until the tabs snap into place. You
may also keep the cables in order by using the cable organizer.
included cables organizer
Figure A
Note!
!
You can place the LCD fl at horizontally to make it
easier to connect the cables. Please make sure
that you place it on an even surface lest the LCD
should be damaged by scratches or collision.
8
Advertisement
Table of Contents
