Pc/Av Mode; Displayport Ver; Source Detection; Key Repeat Time - Samsung U32J590UQ Series User Manual

PC/AV Mode

Set PC/AV Mode to AV. The picture size will be enlarged.
This option is useful when you view a movie.
• Set to PC when connected to a PC.
• Set to AV when connected to an AV device.
― Supplied for the wide models only such as 16:9 or 16:10.
― If the monitor (when set to HDMI1, HDMI2, DisplayPort) is in power saving mode or is displaying the
message Check Signal Cable, press the
or AV.

DisplayPort Ver.

Select your Displayport.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the monitor (when set to HDMI1, HDMI2, DisplayPort) is in power saving mode or is displaying the
message Check Signal Cable, press the
or 1.2↑.
― If you select 1.1, the maximum resolution of your screen drops to 2560 x 1440 due to the limitations in HBR1
transmission speeds.

Source Detection

Select either Auto or Manual as the method to recognize input signal.
― Not available when
PIP/PBP Mode is set to On.
icon to display the On Screen Display (OSD). You can select
icon to display the On Screen Display (OSD). You can select

Key Repeat Time

Control the response rate of a button when the button is pressed.
Acceleration, 1 sec, or 2 sec can be selected. If
when a button is pressed.

Power LED On

PC
Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.

Reset All

Return all the settings for the product to the default factory settings.
1.1
No Repeat is selected, a command responds only once
37