Default Settings - S&P 6002-A Installation, Operation And Maintenance Manual

seconds to stop.
T indicates alarm 1 on due to high ambient temperature (setting 51). Useful for summer ventilation.

Default Settings

User settings are factory pre-loaded with default values to facilitate set up and can be changed at any time. Upgrading firmware will not
affect user settings.
Alarm thresholds should be set to suit local regulations. Default values for these are general guidelines only.
Changing Settings
Press → and ← to move through the settings. If the keypad lock is on then enter the password first. The screen will display the setting number
0, 1, 2, etc. plus the short description (e.g. AL1 for Alarm 1 and the current setting.)
Press the ↑ or ↓ buttons to increase or decrease the setting.
To save, press ↑ and ← buttons at the same time. The word "OK" will appear. If you do not see "OK" and the new value it is because the
buttons were not pressed simultaneously. Try again.
List of Settings Sensor A (upper socket) Settings
NO. Name Description
0 AL1 Alarm 1 threshold, activates relay 1
1 A1Del Alarm 1 Delay on (seconds)
2 A1Off Alarm 1 Delay off (seconds)
3 AL2 Alarm 2 threshold, activates relay 2
4 A2Del Alarm 2 Delay on (seconds)
5 A2Off Alarm 2 Delay off (seconds)
6 AL3 Alarm 3 threshold, sounder and strobe
7 A3Del Alarm 3 Delay on (seconds)
8 A3Off Alarm 3 Delay off (seconds)
9 A1Tx Alarm 1 transmit message, CAN network
10 A1Tx Alarm 1 transmit message, CAN network
1 1 A1Tx Alarm 1 transmit message, CAN network
12 A2Tx Alarm 2 transmit message, CAN network
13 A2Tx Alarm 2 transmit message, CAN network
14 A2Tx Alarm 2 transmit message, CAN network
15 A3Tx Alarm 3 transmit message, CAN network
16 A3Tx Alarm 3 transmit message, CAN network
17 A3Tx Alarm 3 transmit message, CAN network
List of Settings Sensor B (lower socket) Settings
NO. Name Description
18 AL1-B Alarm 1 threshold, activates relay 1
19 A1Del Alarm 1 Delay on (seconds)
20 A1Off Alarm 1 Delay off (seconds)
21 AL2-B Alarm 2 threshold, activates relay 2
22 A2Del Alarm 2 Delay on (seconds)
23 A2Off Alarm 2 Delay off (seconds)
24 AL3-B Alarm 3 threshold, sounder and strobe
25 A3Del Alarm 3 Delay on (seconds)
26 A3Off Alarm 3 Delay off (seconds)
27 A1x,A1Tx Alarm 1 transmit message, CAN network
Range
by sensor
0-999
0-999
by sensor
0-999
0-999
by sensor
0-999
0-999
0-255
0-255
0-255
0-255
0-255
0-255
0-255
0-255
0-255
Range
by sensor
0-999
0-999
by sensor
0-999
0-999
by sensor
0-999
0-999
0-255
Default
30
20
30
20
180
20
1
2
3
Default
30
20
30
20
180
20
1