Table of Contents
Advertisement
152958 39/0en
16-02-2005
Operating instructions
What to do, when...
Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by a sequence of intermittent
audible signals.
The point-shaped optical signal on the floor beneath the dishwasher's
door is flashing (not visible if the appliance has been installed higher
up with a furniture door mounted flush).
Open the dishwasher door, in the digital display is visible a fault code
(see following chart).
Carry out the following suggested corrective actions.
Fault code / Malfunction
in the digital display
appears
The machine does not fill
with water
in the digital display
appears
The dishwasher will not
drain
in the digital display
appears
34
10:50
Pagina 34
Possible cause
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
The sink spigot is blocked.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Anti-flood device has
activated.
Solutions
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
Check the water inlet hose
connection.
Clean out the sink spigot.
Check the water drain
hose connection.
Close the water tap and
contact your local Service
Force Centre.
Advertisement
Table of Contents
