AMTC LIQUIDFLO ASD-400EL Installation & Operation Manual

Installation Diagram

Spout
Countertop or Sink
Max. Thickness: 2" (50mm)
Spacer
Mounting Bracket
Threaded Stem
Soap Bottle Coupler
Liquid Soap Bottle
(800 mL)

Installation Instructions (refer to installation diagram above)

1. If hole is not present drill a 1" (25.4mm) hole on countertop (refer to installation template on page 3).
2. Mount the spout onto the countertop or sink and hand tighten mounting bracket and spacer without damaging sensor cable.
3. Install batteries into battery pack and mount battery pack onto back wall using provided hardware
(battery pack must be installed within 15" (380mm) of spout).
Note: An optional 6 Volt AC power adapter (Part# AD05) can be purchased separately if electrical power is required.
4. Screw soap bottle coupler onto threaded stem and hand tighten.
5. Fill up bottle with liquid soap (Important: Use low viscosity liquid hand soap with no abrasives).
*Viscosity Range: (mPa•s or Cp): 100-3800 / pH Range: 5.0 - 9.0
*Failure to use soap products within the required range of viscosity and pH may result in damage to product and
void warranty.
6. Screw soap bottle onto soap bottle coupler and hand tighten.
7. Connect sensor cable onto battery pack (you will hear pumps and soap will purge for approximately 5 seconds).
8. Soap dispenser is now ready for use.

Parts List

Ref # Part #
A ASD-4SPT Spout
A-1 ASD-4SPTEL EL Spout (6" Long)
B ASD-4FA Spout Filter Assembly
C
ASD-4SPA Spacer
D ASD-4MB Mounting Bracket
E ASD-4SBC Soap Bottle Coupler
F ASD-4MSC
Mounting Screws
800ml Soap Bottle
G ASD-4SB
H ASD-4BP Battery Pack
6-Volt AC Power Adapter
AD05
I
(Optional)
6-Volt AC Power Adapter
AD05-2
J
w/Extension for 2 Devices
Extension Only for AC
K AD05-2-EXT
Power Adapter
AUTOMATIC LIQUID SOAP DISPENSER
INSTALLATION & OPERATION MANUAL
™
Sensor Cable
Liquid soap refill only
(Solo jabon de liquido)
www.amtcorporation.com
Reset Button
Press and hold for 7 seconds to prime soap
(Aprete y sostenga por 7 segundos para subir el jabon)
Battery Pack
4-D Size
(Batteries Sold Separately)
Description
ASD-400 LIQUIDFLO™
Attention:
Make sure sensor cable is passed
through the opening of the spacer
to avoid damage.
AD05
(Optional) 6 Volt AC Power Adapter
(Optional-Sold Separately)
Reset Button
A A-1
I
(Optional-Sold Separately)
Page 1 of 3
ASD-400
Low Battery Indicator
Low Soap Indicator
B C
Liquid soap refill only
(Solo jabon de liquido)
G
J
(Optional-Sold Separately)
ASD-400EL
Flashing BLUE LED
Flashing RED LED
D E
F
www.amtcorporation.com
Reset Button
Press and hold for 7 seconds to prime soap
(Aprete y sostenga por 7 segundos para subir el jabon)
H
K
(Optional-Sold Separately)