AMTC Liquidflo ASD-400 Installation & Operation Manual
  1. Manuals
  2. Brands
  3. AMTC Manuals
  4. Dispenser
  5. Liquidflo ASD-400
  6. Installation & operation manual

AMTC Liquidflo ASD-400 Installation & Operation Manual

Automatic liquid soap dispenser
Hide thumbs
1
2
3
4

Advertisement

Table of Contents

ASD-400 LIQUIDFLO™
AUTOMATIC LIQUID SOAP DISPENSER
INSTALLATION & OPERATION MANUAL
™

IMPORTANT PRE-INSTALLATION NOTE

READ BEFORE INSTALLATION:
During the initial installation you may
need to prime the soap 4-5 times to get
the soap to pump through the spout.
In some cases there may be some
trapped air in the system that does not allow
the soap to initially prime. If this is the case
you will need to blow through the soap filter
to clear the trapped air. Then prime the soap
again. The soap should now prime through
the spout.
For further assistance please call
Technical Support at 1-800-874-7822.
Soap Filter
Page 1 of 4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Liquidflo ASD-400 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for AMTC Liquidflo ASD-400

Summary of Contents for AMTC Liquidflo ASD-400

  • Page 1 ASD-400 LIQUIDFLO™ AUTOMATIC LIQUID SOAP DISPENSER INSTALLATION & OPERATION MANUAL ™ IMPORTANT PRE-INSTALLATION NOTE READ BEFORE INSTALLATION: During the initial installation you may need to prime the soap 4-5 times to get the soap to pump through the spout. In some cases there may be some trapped air in the system that does not allow the soap to initially prime.
  • Page 2 ASD-400 LIQUIDFLO™ AUTOMATIC LIQUID SOAP DISPENSER INSTALLATION & OPERATION MANUAL ™ Installation Diagram Spout Countertop or Sink Max. Thickness: 2” (50mm) Spacer Sensor Cable Attention: Make sure sensor cable is passed Mounting Bracket ASD-400 ASD-400EL through the opening of the spacer Threaded Stem to avoid damage.
  • Page 3 ASD-400 LIQUIDFLO™ AUTOMATIC LIQUID SOAP DISPENSER INSTALLATION & OPERATION MANUAL ™ Soap Refill Instructions: 1. Flashing Red LED Indicates Low Soap 2. Unscrew Liquid Soap Bottle 3. Refill Liquid Soap Bottle Important: Use low viscosity liquid hand soap with no abrasives. Flashing Red LED *Viscosity Range: (mPa•s or Cp): 100-3800 pH Range: 5.0 - 9.0...
  • Page 4 Counter Top Warranty AMTC WARRANTS THE ASD-400 SOAP DISPENSER TO BE FREE OF DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF THREE (3) YEARS FROM DATE OF PURCHASE, WHEN PROPERLY INSTALLED AND UNDER NORMAL USE AND SERVICE. THESE PROVISIONS DO NOT INCLUDE THE BATTERIES SHIPPED WITH THE PRODUCT.

Table of Contents