Ricoh Pro C651EX Troubleshooting Manual page 79

When printing on both sides
<If it is acceptable for the image to be incompletely printed at its edge>
1. In [Advanced Settings] for the custom paper in use, select [14: Adjust Erase
Margin of Trailing Edge] and increase the value by 0.5 mm.
2. Print the image. Is the problem resolved?
Yes Finished!
No Keep increasing the value by 0.5 mm until the problem is resolved.
If the problem persists even though the setting has reached its
maximum value, contact your service representative.
<If it is not acceptable for the image to be incompletely printed at its edge>
1. In [Advanced Settings] for the custom paper in use, select [08: Adj Image
Position of Side1 With Feed] and increase the value by 0.5 mm.
2. Select [09: Adj Image Position of Side2 With Feed] and decrease the value
by 0.5 mm.
3. Print the image. Is the problem resolved?
Yes Finished!
No Keep increasing/decreasing the value by 0.5 mm until the problem is
resolved.
If the problem persists even though the setting has reached its
maximum/minimum value, contact your service representative.
79