Starting And Operating; Starting The Engine; Automatic Transmission; Keyless Enter 'N Go™ - Ignition - Chrysler 300 2022 Owner's Manual

Table of Contents

Advertisement

86

STARTING THE ENGINE

Before starting your vehicle, adjust your seat,
adjust the inside and outside mirrors, fasten your
seat belt, and if present, instruct all other
occupants to buckle their seat belts.
WARNING!
When exiting the vehicle, always make sure
the ignition is in OFF position, remove the key
fob from the vehicle and lock the vehicle.
Never leave children alone in a vehicle, or with
access to an unlocked vehicle. Leaving chil-
dren in a vehicle unattended is dangerous for
a number of reasons. A child or others could
be seriously or fatally injured. Children should
be warned not to touch the parking brake,
brake pedal or the transmission gear selector.
Do not leave the key fob in or near the vehicle
(or in a location accessible to children), and do
not leave the ignition (of a vehicle equipped
with Keyless Enter 'n Go™) in the ACC or ON/
RUN position. A child could operate power
windows, other controls, or move the vehicle.

STARTING AND OPERATING

Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build-up
may cause serious injury or death.
A
T
UTOMATIC
RANSMISSION
The gear selector must be in the PARK position
before you can start the engine. Apply the brakes
before shifting into any driving gear.
Shift into or out of PARK or REVERSE only after
the vehicle has come to a complete stop.
Do not shift between PARK, REVERSE,
NEUTRAL, or DRIVE when the engine is above
idle speed.
Before shifting into any gear, make sure your
foot is firmly pressing the brake pedal.
(Continued)
WARNING!
CAUTION!
K
E
'
G
™ — I
EYLESS
NTER
N
O
This feature allows the driver to operate the
ignition switch with the push of a button, as long as
the Remote Start/Keyless Enter 'n Go™ key fob is
in the passenger compartment.
N
S
ORMAL
TARTING
To Turn On The Engine Using The ENGINE START/
STOP Button
1. The transmission must be in PARK.
2. Press and hold the brake pedal while pushing
the ENGINE START/STOP button once.
3. The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the
starter will disengage automatically after 10
seconds.
4. If you wish to stop the cranking of the engine
prior to the engine starting, push the ENGINE
START/STOP button again.
NOTE:
Normal starting of either a cold or a warm engine is
obtained without pumping or pressing the accel-
erator pedal.
GNITION

Advertisement

Table of Contents
loading

Table of Contents