Wiring Procedure - Tektronix Keithley 7702 Instructions For Use Manual

Wiring procedure

Use the following procedure to make connections to the 7702 switching module. Make all connections using the
correct wire size (up to 20 AWG).
All wiring must be rated for the maximum voltage in the system. For example, if 1000 V is
applied to the front terminals of the instrument, the switching module wiring must be rated
for 1000 V. Failure to recognize and observe normal safety precautions could result in
personal injury or death.
Equipment needed:
▪
Flat-blade screwdriver
▪
Cable ties
To make connections to the 7702 switching module:
1. Make sure all power is discharged from the 7702 switching module.
2. Use a screwdriver to turn the access screw to unlock and open the cover.
077144400 / April 2018
Model 7702 Multiplexer Module Instructions for use with DAQ6510
Figure 2: Screw terminal access
3