Hector hc3 series horizontal windlasses 700/1000/1500w (37 pages)
Summary of Contents for Quick GP Series
Page 1
GP Series REV 000A March, 2023 HORIZONTAL WINDLASSES ROPE AND CHAIN ON A SINGLE GYPSY GP2 500 GP2 1500 GP2 2000 GP2 1200 GP2 1500 D GP2 2000 D GP2 1200 D GP2 1500 FF GP2 2000 FF GP2 1200 FF...
8 - Product disposal 9 - List of components GP2 500 10 - List of components GP2 1200 11 - List of components GP2 1500/2000 12 - Spare parts 13 - Dimensions QUICK GPSeries INSTALLATION AND USER’S MANUAL - REV000A...
1/2” (12.7 mm) Rope size** (*) For gypsy codes, see the exploded drawing from page 14 to 17 (**) The values in the table refer to a polyester rope featuring 3 strands with rope/chain junction according to the Quick system ®...
• Control system via RRC radio GP Series 3 - Introduction BEFORE USING THE PRODUCT, PLEASE READ THIS USER’S MANUAL CAREFULLY. IF IN DOUBT, PLEASE CONSULT YOUR QUICK® DEALER. 3.0 - Important notes This manual features Warning and/or Caution symbols that are important for safety.
• The splice between the rope and the chain must be tightly woven for the rope to slide easily into the gypsy shape. For any problem or request, feel free to contact Quick® Technical Service. • For improved safety, we recommend installing at least two controls to operate the windlass in case one is damaged.
If this is not the case, compensate the difference appropriately (fig. B). A lack of parallelism could result in a loss of motor power. The deck thickness must be included among the figures listed in the table. In case of different thickness, please contact your Quick ® dealer. 5 mm (3/6”) C PEAK DEPTH AND BOW ROLLER HEIGHT There must be no obstacles to the passage of cables, rope and chain under deck (fig. 1C).
• DO NOT operate the windlass by using the electrical power when the handle is inserted in the drum or into the gypsy cover. • Quick® recommends using a suitable power fuse/thermal-magnetic/hydraulic-magnetic protection for the motor used, to protect the motor from overheating or short circuits.
If the hydraulic magnetic switch, has tripped, reset it and wait a few minutes before weighing anchor once again. If, after a number of attempts, the windlass is still blocked, we suggest to move the boat to release the anchor. QUICK GPSeries INSTALLATION AND USER’S MANUAL - REV000A...
• Release the chain. • Restore windlass power supply. With the automatic free fall system deactivated, the chain can only be lowered with electrical drive or manually (see section 6.1 - CLUTCH USE). QUICK GPSeries INSTALLATION AND USER’S MANUAL - REV000A...
Carefully remove the chain from the gypsy or the rope from the drum. Quick® windlasses are made of materials resistant to the marine environment: it is essential, in any case, to periodically remove salt deposits that form on the external surfaces to avoid corrosion and consequently damage to the device.
GROWER O-RING WINDLASS BASE CHAIN STRIPPER SCREW OIL SEAL SCREW SCREW MOTOR SCREW SCREW WINDLASS COVER PRESSURE LEVER PIN PRESSURE LEVER SCREW PRESSURE LEVER SPRING WASHER PRESSURE LEVER ROLLER SHELL REED SENSOR QUICK GPSeries INSTALLATION AND USER’S MANUAL - REV000A...
BUSH WINDLASS BASE BRAKE PIN COVER DRUM SCREW KNOB OIL SEAL MOTOR SCREW SCREW SCREW DOWEL GRUB SCREW WINDLASS COVER SPRING PRESSURE LEVER SCREW WASHER PRESSURE LEVER SPRING ROLLER SHELL PRESSURE LEVER QUICK GPSeries INSTALLATION AND USER’S MANUAL - REV000A...
Need help?
Do you have a question about the GP Series and is the answer not in the manual?
Questions and answers