Instructions For Replacing The Water Bottle - Honeywell HWTLMT508W User Manual

INSTRUCTIONS FOR REPLACING THE WATER BOTTLE

WARNING: Only use a 10 or 20 liter bottle with this water dispenser.
WARNING: Make sure the unit is turned off when the hot and cold water tanks
are empty. There must be water inside the tanks before turning on any switches.
Remove the seal from the bottle lid.
This unit has a pointed funnel to prevent spillage.
Carefully lift the carboy. A bottle weighs approximately 20 kgs (for each 20L
bottles). Bend your knees to lift the bottle, not your back.
DO NOT place your hands blocking the opening of the bottle while you are
placing it. Please ask for help if you are unable to lift it.
Flip the 10 or 20L bottle over the dispenser and carefully allow the neck of
the carboy to slide into the funnel, making sure the bottle cap slides toward
the tip of the funnel.
The tip of the funnel will break the seal on the bottle lid, allowing water to flow
without spilling from the jug into the funnel and water tanks.
Plug the unit into an outlet and allow all tanks to fill with water for
approximately 3 minutes.
Press on faucets to confirm water is flowing from all faucets.
Turn on the hot and cold water switches. Allow the unit to reach minimum hot
and cold water temperatures. This will take approximately 30-45 minutes and
the indicator lights will turn off.
Test the temperature of the water by pressing each of the faucets.
Your water dispenser is ready to be used.
EN 8