Hunter 52485 Installation Manual page 9

Light Kit Screw
bag
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Partially install two of the light kit screws
found in the bag. It does not matter
which two screw holes you choose. Connect
the single-pin connectors from the LED
assembly to the connectors from the fan.
Connect the white wires together. Connect
the blue and black wires together.
Note:
Fan style may vary.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Note:
Fan style may vary.
Ceiling Bracket Downrod
Assembling the LIght Kit
2 of 6
Feed the wire plug through the center hole
of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
2 of 6
Light Kit Screw
bag
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
Installing the Bulbs and Glass
Tab
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan Wiring
Connect 9-pin to the plug
connector found in the
switch housing area of
the light kit assembly.
Make sure to line up the
colored markings on the
connectors.
Turn the light kit counterclockwise until the light
kit screws are firmly situated in the narrow end
of the keyhole slots. Install the third screw and
tighten all three screws securely.
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Canopy Blades
1 of 6
Light Kit Screw
bag
Insert the third screw, found in the
hardware bag, into place and then
tighten all three screws.
1 of 6
Light Kit Screw
bag
WARNING
ON
Light Glass/Bulbs
1886
8