Electrolux IK3318CAL User Manual page 18

18 www.electrolux.com
Problem
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
DEMO appears on the dis‐
play.
A or
shown instead of numbers
on the temperature dis‐
play.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
The FastCool function is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The FastCool function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in the
demonstration mode.
Temperature sensor prob‐
or symbol is
lem.
Solution
Switch off FastCool func‐
tion manually, or wait until
the function deactivates
automatically to set the
temperature. Refer to
"FastCool function" sec‐
tion.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to "FastCool func‐
tion" section.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and tips" chapter.
To exit the demonstration
mode, press and hold the
OK button for approximate‐
ly 10 seconds until you
hear a long sound and the
display turns off for a short
time.
Contact the nearest Au‐
thorized Service Centre.
The cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.