Subscribe to Our Youtube Channel
Related Manuals for Joie i-Gemm I1404C
Summary of Contents for Joie i-Gemm I1404C
- Page 1 INSTALLATION INSTRUCTIONS i-Gemm MODEL I1404C IMPORTANT: KEEP THIS INSTRUCTION BOOKLET IN THE PLACE PROVIDED ON THE CHILD RESTRAINT...
-
Page 2: Table Of Contents
Contents This Child Restraint is suitable for children up to approxi- mately 12 months of age. Quick Reference .............. 2 WARNINGS ..............3 Additional Warnings ..........4 & 5 Before installation and use of this child restraint check that Features ................6 it is suitable for the size of your child. -
Page 3: Warnings
Overview WARNING IMPORTANT: Also read the following instructions carefully • Use the restraint exactly as shown in the instructions. • Fit the restraint firmly to the car seat. Tether Strap Carry Handle must always be used when the must always be locked •... -
Page 4: Additional Warnings
ADDITIONAL WARNINGS ADDITIONAL WARNINGS Only install child restraint TO BE USED WITH A LAP-SASH/LAP ONLY SEATBELT in a forward facing vehicle OR ISOFIX LOW ANCHORAGES IN THE BACK OF MOST seat. Never install in a seat CARS WITH FORWARD FACING SEATS. that faces the rear or the side of the vehicle. -
Page 5: Features
Features Installation - General 1 Tether Strap 7 Vehicle Belt Lock-Off Where to install the child 2 Child Restraint Release 8 Bubble Level Indicator restraint? Lever 9 Recline Foot Fold Latch Only install the child re- 3 Snap Hook straint in a forward facing 10 Recline Foot 4 Tether Strap Anchorage vehicle seat. -
Page 6: Installation - Vehicle Belts
Installation - General Installation — Vehicle Belts REARWARD-FACING 1 Position base on a Use the Belt Path BELT PATH forward facing vehicle labels as a guide for seat. correct belt placement. Top Tether Adjust base so bubble Anchorage is between the black patches. -
Page 7: Checklist - Vehicle Belt Installation
Installation — Vehicle Belts 5. Hold vehicle belts tight and engage the belt Place the base on the lockoff. vehicle seat in line with a top tether anchorage point. IMPORTANT Pull belts tight. 1. Open the belt lockoff. Loose belts are dangerous. -
Page 8: Installation - Isofix Compatible Connectors
Installation — ISOFIX Installation — ISOFIX Compatible Connectors Compatible Connectors Some vehicles are fitted The ISOFIX straps pass with ISOFIX low anchorage through the same openings points. in the base as used for the vehicle belts. These are are found at the Use the Belt Path labels bottom of the back seat as a guide for correct belt... - Page 9 Installation — ISOFIX 4. Pull each adjustment strap equally until the ten- Compatible Connectors sion indicators show green. See general installation IMPORTANT Open Recline Foot instructions on pages 7 & 8. Straps must be pulled tight 1 Turn base over. Bring the recline foot to the open po- sition.
-
Page 10: Checklist - Isofix Installation
Fitting Restraint to Base Checklist — ISOFIX Installation To Install 1. Level indicator 2. Belt is tight. bubble is fully in the First make sure there is clear area. nothing in or on the base (blankets, toys etc). These may stop the restraint from latching securely. -
Page 11: Warnings - Tether Strap
How to use the Tether Strap WARNINGS – Tether Strap Always use the tether strap. TETHER STRAP Connect the tether strap to the built-in anchorage fitting THIS RESTRAINT MUST BE ATTACHED TO A CHILD in the vehicle, or if there is not one available, install the RESTRAINT UPPER ANCHORAGE POINT IN THE CAR. - Page 12 How to use the Tether Strap How to use the Tether Strap 1. Connect the snap hook Do not adjust so tight that securely to the anchorage it lifts the child restraint off the vehicle seat. fitting. Note: there are several different looking types of anchorage, yours may not look like this.
-
Page 13: Checklist - Tether Strap
Checklist — Tether Strap Installation — Tether Anchorage Most cars have several 1. Is snap hook securely The threaded hole for threaded holes to fit the attached to tether anchor- the anchorage bolt age? tether anchorage to. may have a plastic cover over it Refer to the vehicle owners handbook for information... -
Page 14: Installation - Tether Anchorage
Installation — Tether Anchorage Installation — Tether Anchorage If the car is fitted with a Attachment If the car is not fitted with Attachment Bolt Bolt child restraint anchorage a child restraint anchorage Anchor point: point: Lock Fitting For sedans only - drill a 9 Locate the anchorage point Washer behind the rear seating... -
Page 15: Use With Strollers
Use with Strollers Cleaning and Maintenance Seat Cover This Joie child restraint can attach to Joie strollers using ™ Wash with cold water and mild detergent. adapters. Instructions are included with the adapters, which are sold separately. Do not iron.
Need help?
Do you have a question about the i-Gemm I1404C and is the answer not in the manual?
Questions and answers