Table of Contents
Advertisement
WASHING & TIMED DRYING
To have a good drying the appliance does not let
you set a too low spin speed for the items to be
washed and dried.
1. Press
to set the drying time value. The
display shows 10 minutes.
The indicator
comes on in the display. The
display shows the set drying value time. for
example:
. After some seconds the display
shows the final time value
duration of the washing and drying cycles (washing
+ drying + anti-crease + cooling phases).
If you set only 10 minutes of drying
after washing, the appliance calculates
also the duration of the anti-crease
and the cooling phases.
2. Press
to start the programme.
In the display the indicator
is locked. The display shows regularly a new time
value.
END OF THE PROGRAMME
The appliance stops automatically. The acoustic
signals operate (if they are active).
For more information see "At the end of the drying
programme " of the previous chapter.
1. Remove the laundry from the appliance.
Make sure that the drum is empty.
2. Keep the door ajar to prevent mildew and
odours.
HINTS AND TIPS
WARNING! Refer to Safety chapters.
THE LAUNDRY LOAD
•
Divide the laundry in: white, coloured,
synthetics, delicates and wool.
•
Obey the washing instructions that are on the
laundry care labels.
•
Do not wash white and coloured items together.
•
Some coloured items can discolour with the first
wash. We recommend that you wash them
separately for the first times.
•
Button up pillowcases, close zippers, hooks and
poppers. Tie up belts.
•
Empty the pockets and unfold the items.
•
Turn multilayered fabrics, wool and items with
painted illustrations inside out.
18
, that is the total
comes on. The door
FLUFF IN THE FABRICS
During the washing and/or drying phase, some
types of fabric, (sponge, wool, sweatshirt) could
release fluff.
The released fluff could stick to the fabrics during
the next cycle.
To prevent the fluff in your laundry, we recommend
that you:
•
Do not wash dark fabrics after you have washed
and dried light coloured fabrics (new sponge,
wool, sweatshirt ) and the contrary.
•
Line dry this type of fabrics at open air when
they are washed the first time.
•
Clean the drain filter.
•
After the drying phase, clean the empty drum,
the gasket and the door with a wet cloth.
HOW TO REMOVE THE FLUFF IN THE
GARMENTS
To remove the fluff inside the drum, set a special
programme:
1. Empty the drum.
2. Clean the drum, the gasket and the door with a
wet cloth.
3. Set the rinse programme.
4. Press at the same time
the cleaning function until the display shows
CLE.
5. Press
to start the programme.
•
Remove hard stains with a special detergent.
•
Wash and pre-treat heavy soil stains before
putting items in drum
•
Be careful with the curtains. Remove the hooks
and put the curtains in a washing bag or
pillowcase.
•
Do not wash laundry without hems or with cuts.
Use a washing bag to wash small and/or
delicate items (e.g. underwired bras, belts,
tights, etc. ).
•
A very small load can cause balance problems
with the spin phase. If this occurs, adjust
manually the items in the tub and start the spin
phase again.
STUBBORN STAINS
For some stains, water and detergent is not
sufficient.
and
to activate
Advertisement
Table of Contents
