Advertisement
•
Double click on the found camera to open setting basic network parameters of the camera according to the
configuration of your network environment, enter the password for the user "admin" set in the camera, and save
by pressing the "Confirm" button
•
Open a Web browser and enter the IP address of the camera
•
Enter the login data and click on the "Login" button
•
After the first login you will be prompted to download and install the WebComponents addition that provides
the stream display in browsers.
•
Save the file (typically WebComponents.exe), close the browser, run the downloaded installation file and follow
the on-screen instructions. After installation is complete, open the web browser again with the camera's IP
address and enter login information. Now you can view the live image from the camera.
Fig. 5: Software iVMS-4200 – searching for
camera in the network
Restoring the factory settings
•
Disconnect the camera from the power supply
•
Press and hold the "Reset" button which is located on the back of the camera
•
Keep the button pressed and connect the camera to power supply
•
Hold the reset button for at least 10 seconds and then release it
•
After a while the camera will start with default parameters
We hope that you will be satisfied with the product. For general questions please contact your direct vendor.
www.imago-video.com
4
IMAGO ICN-x1P1 NW 2.8 (W) – Quick Installation Guide
October 2014
www.imago-video.com
Advertisement
