Husqvarna 346XP E-tech Operator's Manual page 13

2. Set the choke control to the control position. This
automatically sets the start/stop switch in the start
position.
3. Push the air purge bulb (A) approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
4. Push the decompression valve (B).
Note:
The decompression valve moves to the
initial position when the product starts.
To start the product on page 13 for
5. Continue to
more instructions.
To prepare to start with a warm engine
WARNING:
engaged when the product is started to
decrease the risk of injury.
1. Move the front handguard forward to engage the
chain brake.
1533 - 001 - 22.01.2021
B
A
The chain brake must be
2. Push the choke control out and then push the choke
control in again.
3. Push the air purge bulb (A) approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
4. Push the decompression valve (B).
Note:
The decompression valve moves to the
initial position when the product starts.
To start the product on page 13 for
5. Continue to
more instructions.
To start the product
WARNING:
a stable position when you start the product.
WARNING:
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
rope around your hand.
B
A
You must keep your feet in
If the saw chain rotates at
Do not twist the starter
13