Boat Assembling - GALA VIKING V Series User Manual

4. BOAT ASSEMBLING

Step 1: Open the boat
- Inspect the condition of the package for and report to your dealer if you find any
damages.
- Remove all the packaging plastic and cardboard carefully. Do not use knife.
- Check the completeness of the boat and make sure that no any parts are missing. You
must report the missing part to your dealer immediately.
Step 2: Assemble and install steering console
Unpack the steering console. Connect and secure the steering cable to the steering
system. Install steering wheel. If your boat is expected to feature electric start – install the
battery tray on the deck under steering console. Assemble and mount control box on the
right side of the console. Make sure the handle in upper position does not touch the railing.
Install the steering console on the deck with bolts with washers and tighten them.
Step 3: Install outboard motor
Install the outboard motor following the motor user's manual.
Step 4: Install two rear seat backs
Unpack the two rear seat backs and install them on the hull with bolts with washers and
tighten them.
Step 5: Inflate the boat
- Open the pump, connect the pump hose to the pump onto inflation opening.
- Connect bayonet adapter of the pump hose to the valve
- Inflate the rear compartments first up to pressure slightly below nominal, and the bow
compartment the last up to the nominal pressure.
In this case the flexible baffles in the tube will move towards the rear compartments and
equalize the pressure in all compartments. You may use the manometer to measure the
pressure level to ensure the best performance of the boat and make sure that the pressure
is about nominal level. Nominal tube pressure is mentioned on Capacity Plate.