Advertisement
Controls
1.
Single Channel IN/OUT:
The signal for the indicated channel is inserted
or received at this connector.
2.
Combined Channel IN/OUT:
The combined signal of all channels is inserted
or received at this connector.
3.
LEVEL ATTEN:
This control reduces the output level of a
single channel.
4.
TUNING/COUPLER:
These controls are used for factory tuning
and adjustment.
Specifications
Channels:
Frequency Range:
Bandwidth:
Insertion Loss:
Low band:
High band:
Attenuator Range:
Skirt Selectivity:
(Alternate Channel) 16 dB
Impedance:
Dimensions:
Weight:
Ordering Information
MX-7
Passive 7-channel VHF Separator-Combiner
MX-7T
Passive 7-channel VHF Separator-Combiner (tuned)
Controls, Specifications and Installation
3 Low band, 4 High band
54-215 MHz
6 MHz
2.5 dB
4.5 dB
0 to 10 dB
75 Ohms
7
1
13˝(L) x 1
/
˝(D) x 3
/
˝(H)
16
4
1
1
/
lbs.
4
Ph:800-421-6511
MX-7
Passive 7-Channel VHF Separator-Combiner
Installation
Used as a separator:
1. Connect the cable from a VHF broadband antenna to the common
connection of the MX-7.
2. Connect a cable from the MX-7 single channel outputs to channel-
ized amplifiers or combining system.
3. Connect a signal level meter to the headend common test point
4. Monitor level while adjusting the LEVEL ATTEN control for each
channel for equal level across all channels
Used as a combiner:
1. Connect the cable from a single channel VHF antenna to the cor-
responding single channel connection of the MX-7. Repeat for each
channel input.
2. Connect a signal level meter to the MX-7 common output.
3. Monitor level while adjusting the LEVEL ATTEN control for each
channel for equal level across all channels
4. Connect a cable from the MX-7 common connection to a VHF
amplifier or distribution system input.
www.picomacom.com
5
Rev. 04/03
Advertisement
