Installation Procedure - Pico Macom BPF Installation And Operation Manual

BPF manual.qxd 7/28/03 10:55 AM
Installation
It is recommended that assistance be available to safely install equipment in equipment racks.
Chassis must be fastened securely in equipment rack before populating with modules.
1. Install BPF in equipment rack (equipment rack sold separately) by supporting the bottom and rear of the unit at the desired
elevation in rack.
2. Line up the side holes of BPF with the tapped equipment rack holes.
3. Insert the provided screws through the side holes in chassis and thread into the tapped equipment rack holes.
4. Fasten the bottom screws first, then fasten top screws (tighten securely).
5. Connect a cable from the antenna or CATV signal source (ensure that all line voltages have been removed) to the input connector
of the BPF.
6. Connect a cable from the output connector of the BPF to the input of a strip amplifier (LBS, HBS, SBS).
7. The strip amplifier output is then combined with other channels using a headend channel combiner (PHC-12G, PHC-24G, or
CHC-16U).
Application
Page 7
Ph:800-421-6511

Installation Procedure

www.picomacom.com
BPF
7
Rev. 07/03