Advertisement
Attach transducers to bracket
11. Use two arm knobs (or two M6x20 cap screws for a more permanent installation) and M6 metal washers from your
ActiveTarget
2 installation kits to attach two ActiveTarget
®
¼ Note: If you attached the large collar to the wrong side of the bracket, you won't be able to install the bottom transducer
because the trolling motor mount will be in the way.
12. Orient the transducers so the cable exiting the transducer is closest to the shaft.
13. Position the top transducer towards the right with the temperature sensor facing up.
14. Position the bottom transducer towards the left with the temperature sensor facing down.
15. Align the lines on the bracket arm with the lines on the transducer.
Move ferrite choke and secure cables to shaft
16. Unclamp the ferrite choke on the cable of the bottom transducer and re-clamp it approximately 100 mm further up the
cable.
¼ Note: This gives you enough space to secure the transducer cable to the shaft above the clamp.
17. Use electrical tape or cable ties to secure both transducer cables to the shaft.
¼ Note: If you use cable ties, don't overtighten them as overtightening can damage the wires inside the cables.
Copyright
Copyright © 2022 Navico Holding AS.
Trademarks
®Reg. U.S. Pat. & Tm. Off, and ™ common law marks. Visit www.navico.com/intellectual-property to review the global trademark rights and accreditations for Navico Holding AS
and other entities.
Warranty
This product's warranty is supplied as a separate document.
Safety, disclaimer and compliance
This product's safety, disclaimer and compliance statements are supplied as a separate document.
More information
Document version: 001
For the latest version of this document in supported languages and other related documentation, visit: www.lowrance.com/downloads/activetarget.
2 transducers to the Scout™ wide bracket arm.
®
Advertisement
