IONODES PERCEPT Replacement Manual
Body camera battery replacement
Hide thumbs
Also See for PERCEPT:
- User manual (60 pages) ,
- Deployment manual (44 pages) ,
- Quick start manual (17 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for IONODES PERCEPT
Summary of Contents for IONODES PERCEPT
- Page 1 Expand your senses Battery Replacement Guide Version 1.1 - February 2023...
-
Page 2: Replacing A Battery Pack
The IONODES PERCEPT wearable IoT camera contains a battery pack that can be replaced if required. Should you determine that your device requires a battery replacement you have the option to return it to IONODES or to perform the replacement procedure yourself. If you opt to replace the battery yourself, you will need to use the parts and tools listed in this document and follow each instruction as described. -
Page 3: Before You Begin
A standard Torx T8 mini screwdriver bit is required to change the battery pack on the PERCEPT Body Camera. Your battery replacement kit contains the needed tools for the procedure as well as replacement screws and matching rubber seals. Before you begin Before you begin the battery replacement procedure, please ensure that: •... -
Page 4: Hardware Revision
Hardware revision The PERCEPT Body Camera benefits from continuous improvements, including upgrades in hardware design. Back cover, SIM card location and battery connector were changed starting in hardware revision R4. Revision R3 or older Revision R4 or newer • Internal SIM card •... -
Page 5: Step 1 - Removing The Back Cover
6. Set the six (6) screws and six (6) seals aside to be discarded as we will be using new screws and seals to reseal the camera. 7. Gently remove the back cover from the camera body using both hands. support@ionodes.com | www.ionodes.com | 1-450-696-1060... -
Page 6: Step 2 - Removing The Battery Pack
Follow these steps to remove the battery pack from your camera: Carefully lift the battery pack out of the camera body making sure not to pull on the battery wires and connector which are connected to the internal electronics. support@ionodes.com | www.ionodes.com | 1-450-696-1060... - Page 7 R4 or newer, the connector is located on the side of the enclosure Revision R3 or older –->Pull STRAIGHT UP Revision R4 or newer–->Pull STRAIGHT from connector A close-up picture of the cable and PCB connectors is shown below. support@ionodes.com | www.ionodes.com | 1-450-696-1060...
- Page 8 Set the battery pack aside for later disposal according to your local laws and regulations. STEP 3 – Connecting the new battery pack For safety reasons, only an IONODES-certified replacement battery pack must be installed. Installing any non-approved battery Warning: pack will void the device’s warranty.
- Page 9 Do not use any metal tool to push down on the connector as this will short-circuit the battery pack. Warning: 3. Place the battery pack inside the camera body following the orientation shown in the image below. support@ionodes.com | www.ionodes.com | 1-450-696-1060...
- Page 10 (the flange flush with the screw threads) or on the bottom side of the camera (where the USB Type-C port is located). Ensure that the wires are not pinched. Revision R3 or older Revision R4 or newer support@ionodes.com | www.ionodes.com | 1-450-696-1060...
- Page 11 USB charger. If this occurs, repeat this procedure (reinstalling the same battery), while ensuring to reseat the connector and reverify the cable is undamaged and properly positioned. support@ionodes.com | www.ionodes.com | 1-450-696-1060...
Need help?
Do you have a question about the PERCEPT and is the answer not in the manual?
Questions and answers