Inspecting And Replacing Belt - Echo shindaiwa CSG-7410ES Service Manual

38
CSG-7410ES
EC741S
CLUTCH SYSTEM and BELT DRIVING SYSTEM
5-2 Inspecting and replacing belt
1. Disconnect pipe (F) from pipe connector on cut-
ter cover assembly.
F
2. Turn bolt (C) counterclockwise to loosen belt
N
tension and then remove 2 bolts (B) and pulley
cover (A).
3. Loosen 2 pre-coated bolts (P) and remove
P
clutch cover (N).
A
B
C
4. Inspect belt (Q) for wearing, peeling, turning,
R
cuts and cracking. Replace with new one as re-
quired.
5. Remove belt (Q) and cutter cover assembly (R).
6. Put new belt (Q) on pulley on clutch drum (S).
S
Q
7. Pass pipe (F) through groove on clutch cover (N).
F
N