Installing Carburetor, Fuel Line And Tank Vent - Echo shindaiwa CSG-7410ES Service Manual

32
4-13 Installing carburetor, fuel line and tank vent
A
C
H
J
K
k1
FUEL SYSTEM
G
E
B
G
C
A
G
C
L
1. Install fuel line (A), pipe joint (B), fuel return line
(C), grommet (D), pipe joint (E), clip (F) and vent
F
line (G) to rear handle as shown.
NOTE: Make sure to pass fuel line (A) through
groove of rear handle as shown.
D
2. Pass fuel line (A), fuel return line (C) and vent
line (G) through holes of crankcase as shown.
3. Install rear handle to crankcase (Refer to "6-1
Replacing cushions and rear handle").
4. Connect fuel return line (C) to long leg of purge
bulb.
5. Hold vent line (G) on intake insulator (H) as
shown.
6. Connect pressure line (L) to joint (k1) on carbu-
retor (K) as shown.
CSG-7410ES
EC741S