Disassembling Starter Assembly - Echo shindaiwa CSG-7410ES Service Manual

8
2-1 Disassembling starter assembly
D
B
D
B
G
J
K
m1
M
STARTER SYSTEM
E
A
C
F
H
A
1. Remove 4 pre-coated bolts and remove starter
assembly (A) from unit.
2. Pinch pawl catcher (B) with adjustable wrench
(C) as shown not to rotate pawl catcher (B).
NOTE: Do not insert rod shaped tool between the
pawls of pawl catcher (B) to secure it, otherwise
damage of pawl catcher (B) may occur.
3. Loosen nut (D) with 10 mm socket wrench (E).
4. Remove nut (D), washer(F) and pawl catcher (B).
5. Remove 4 screws and cover (G).
NOTE: Inspect oilseal of cover (G). If damaged,
replace the oilseal with new one.(Refer to "2-3 Re-
placing oilseal").
6. Remove shaft (H) and power spring (J).
7. Pull out starter rope (K) about 30 cm (12 in) and
hold rope reel (M) by hand. Loop excess rope in
rope reel notch (m1) as shown.
8. Rotate rope reel (M) counterclockwise to release
tension of rewind spring.
CSG-7410ES
EC741S