Operation - Hama Fineline Operating Instructions Manual

5. Inbetriebnahme
Inserting the battery (Pic.1)
• Use one A27 battery.
• To get started using the product or to change
the battery, open the product by removing
the screw(s).
• Remove the protective foil (if present) from
the A27 battery.
• Insert the A27 battery into the battery
compartment. Be sure the polarity is correct.
• Screw the device back together.

Operation

• Press the 'on' button (2) to switch the
product on. The 'Fineline' active pen will
automatically switch off if it has been inactive
for more than one minute.
• The LED glows blue if there is sufficient
battery charge.
• If the brightness of the LED light diminishes,
the battery is getting weaker.
• The battery must be replaced once the LED
light has completely gone out.
Note - Damage to the display
• To avoid causing damage to the display,
please observe the following points:
• Avoid exerting strong pressure on the
display with the input pen.
• Make sure that the display and the input
pen are clean before they are used. Small
debris such as grains of sand can cause
scratches when using the input pen.
Note - Display protector / protective
glass
Using display protectors / protective glass
can lead to the function of the input stylus
being restricted.
Adjusting the signal strength
Switch the device on. Hold the 'Fineline' active
pen vertically to the capacitive touch display and
draw a horizontal line from left to right.
The signal strength is correct if the line appears.
Increase the signal strength by twisting the tip
(3) out if:
• the line does not appear.
• you need a tilt angle of less than 45 degrees.
If a broken line appears with a tilt angle of less
than 45 degrees, reduce the signal strength by
twisting the tip (3) in.
6. Care and Maintenance
Only clean this product with a slightly damp,
lint-free cloth and do not use aggressive
cleaning agents.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use
of the product or from failure to observe the
operating instructions and/or safety notes.
8. Technical Data
Power supply
Weight
Dimensions
(length x diameter)
Aktive Stylus "Fineline"
12 V
1 x Batterietyp A27
16 g ( without battery )
117 x 12 mm
3