Philips WACS700 Firmware Upgrade Manual page 8

Upgrade WAS700 Station:
6. Press STANDBY-ON to turn on WAS700 Station
→ Upgrading starts automatically
→ The display shows "Updating firmware, please wait......" .
A progress bar appears
→ Station will reboot itself twice during the upgrading process
→ After about 5 minutes, Station returns to HD mode. The upgrading is
completed
(Note: - Keep your Station turned on during the upgrading.)
Helpful hints:
- To check the firmware version, see Preparation: Verifying firmware
version.
- If you have any problem, see troubleshooting.
__________________________________________________________________
5. Troubleshooting
If the Station's display shows: "Firmware is damaged, restoring a new copy ..."
or "Center is connected, retrieving firmware"
Follow the DON'T below:
a. DON'T restore Center's setting
→ "Restore Setting" on Center)
b. DON'T delete Stations
"Station Mgnt" → "Delete Station" on Center)
c. Do NOT change Center's Wi-Fi setting
Then,
1. If the progress bar is moving on, wait and upgrading will start later on the
Station
2. If the progress bar stops moving and/or Station's display shows "Error Code
xxx", turn off the Station and then turn it on.
3. If Step 2's problem still exists, check there is no Wi-Fi interference around and
reduce the distance between Center, Station and Wireless router/Access Point
(if applicable)
__________________________________________________________________
(Don't select "Menu" → "Setting"
from Center (Don't select "Menu" →