Philips WACS700 Firmware Upgrade Manual page 4

→ Upgrading starts automatically
→ The display shows "Updating firmware, please wait......" .
A progress bar appears
→ Center will reboot itself twice during the upgrading process
→ After about 5 minutes, Center returns to HD mode. The upgrading is
completed
(Note:
Upgrade WAS700 Station:
3. Press STANDBY-ON to turn WAS700 Station
→ Upgrading starts automatically
→ The display shows "Updating firmware, please wait......" .
A progress bar appears
→ Station will reboot itself twice during the upgrading process
→ After about 5 minutes, Station returns to HD mode. The upgrading is
completed
(Note:
Helpful hints:
- To check the firmware version, see Preparation: Verifying firmware
version.
- If you have any problem, see troubleshooting.
- Keep your Center turned on during the upgrading.)
- Keep your Station turned on during the upgrading.)