Philips WACS700 Connecting Manual page 6

Express Installation
1
Check the wired router is working properly and
enable its DHCP
2
Click to select Music Center connect to Wired
Network
3
When prompted by the installation wizard, connect
the supplied Ethernet cable (straight cable) to the
ETHERNETports on Center and PC
4
When the screen on the right appears, select
"Obtain an IP address automatically"
5
Follow the screen instructions to finish the PC con-
nection.
➜
The screen shows: "The settings of Music Center
have been changed...... "
6
To apply new settings, you need to power off
WAC700 Center, and then power it on again
7
Click Next to start DMM installation
➜
The icon
desktop after DMM installation is finished
8
Disconnect the supplied Ethernet cable from your
PC and Center., and then, connect your PC and
Center to the wired router
Notes:
– When using a wireless router, keep it at least 0.5 meter away from WAC700 Center.
– If you are Windows 2000 user, check Service Pack 2 is installed.
– Select PC's network adapter that connects Center via the
supplied Ethernet cable, if you have installed more than
one network adapter on your PC.
– If you add/remove a network adapter to/from
your PC, you need to re-install the PC connection. Follow the steps under Custom
Installation: Change Network Settings.
– In Option 3:Wired connection, avoid assigning the IP address manually as: IP address:
169.254.xxx. yyy; Subnet mask: 255.255.0.0. Such an IP address will cause conflict with the
WiFi network of WACS700 Center and Station, resulting in Center's disabled Ethernet port.To
restore the disabled Ethernet port, restore your WAC700 Center to its default settings (see
Chapter Reset in the User Manual).
appears on your computer
ETHERNET
Center