Table of Contents
Advertisement
left page (12)
of A71 FCC, LAM en, A31008-H2710-A43-1-4A19 (23.08.2005, 08:52)
Making a phone call
12
Change phonecode
You define and enter the phone code
(4 - 8 digits) when calling a phone code
protected function (e.g.
for the first time. It is then valid for all
protected functions. If it is entered incor-
rectly three times the phone is locked.
Contact the Siemens Service.
Clear SIM card barring
If the PIN is entered incorrectly three
times, the SIM card is barred. Enter the
PUK (MASTER PIN) provided by your serv-
ice provider with the SIM card. If the PUK
(MASTER PIN) has been lost, please con-
tact your service provider.
Prevent accidental activation
Even if PIN use is deactivated (p. 11) con-
firmation is required to switch on the
phone.
This prevents accidental activation of the
phone, e.g. when you are carrying it in a
bag or when you are travelling in an
aircraft.
After pressing and holding the On/Off/End
B
key
select
or abort the operation with §Cancel§.
Making a phone call
Dialling with number keys
The phone must be switched on (standby
mode). Enter the number (always with
prefix, if necessary with the international
dialling code). Press
digit, press and hold to clear the entire
phone number. To dial press the
End call
Press the End key
even if the person on the other end of the
line has hung up first.
call, p. 13)
Direct
to switch on the phone
§OK§
§Clear§
to clear the last
A
key.
B
briefly. Press this key
Set volume
E
Use the scroll key
to start adjusting
the volume during conversation. Set vol-
G
ume with
.
Redial previous numbers
To redial the phone number last called,
A
press the Call key
twice. To redial other
numbers that were dialled previously,
pick out the required phone number from
G
the list with
, then press
When a number is busy
For automatically dialling the phone
number for up to 15 minutes at increas-
ing intervals, press
§Auto
ringing when the busy number is free,
L
press
§Call back§
(
). Press
beep will remind you to redial the dis-
payed phone number after 15 minutes.
Accept call
The phone must be switched on (standby
mode). An incoming call will interrupt
any other use of the phone.
A
Press
§Answer§
or
.
If the phone number has been transmitted
by the network, it is displayed. If the number
and the name are stored in the Phonebook,
the corresponding name is displayed in-
stead. If set, an animation can be dis-
played instead of the bell icon.
Reject call
B
§Reject§
or
press briefly.
Held call
Make a new connection during a call with
J
¢
¢
y menu§
Hold
number, also from Phonebook:
you can swap back and forth be-
§Swap§
tween both calls.
Additional costs will be incurred for the
2nd phone connection.
A
to dial.
dial§. For phone
§Prompt§
and a
(dial new phone
F
). With
Advertisement
Table of Contents
