Philips LX7000SA Service Manual page 11

DISMANTLING INSTRUCTIONS
Dismantling of the Front Panel Assembly
1) Remove 7 screws H (see Figure 12 and Figure 13) and
uncatch 2 catches H1 (see Figure 13) to loosen the Front
Panel Assembly from the set.
- 4 screws on top of the Front Panel Assembly
- 3 screws and 2 catches H1 at the bottom of the Front
Panel Assembly
- See Service position F
2-3
2) Make sure to unplug the cable (if obstructed) before
separate the Front Panel Assembly from the set (see
Figure 14).
Figure 12
Figure 13
Figure 14
Dismantling of the Key & Control Boards
1) Remove 1 screw K (see Figure 15) to loosen the
Headphone Board (pos 1105-D).
2) Remove 6 screws L (see Figure 15) to loosen the
Volume& IR Board (pos 1105-C).
3) Remove 2 screws M (see Figure 16) to loosen the Power
On/Off Board (pos 1105-A).
Repair Hints
1) During repair it is possible to disconnect the ECO6 Tuner
Board completely unless the fault is suspected to be in
that area. This will not affect the performance of the rest
of the set.
2-3
4) Remove 2 screws N (see Figure 16) to loosen the
Bracket LED SACD (pos 109) and SACD LED Board
(pos 1105-B).
5) Remove 3 screws P (for LX8000SA 2 screws only) and
uncatch 2 catches P1 (see Figure 16) to loosen the Top
Key Board (pos 1105-E).
Figure 15
Figure 16
2) The flex cables are very fragile, care should be taken not
to damage them during repair. After repair, be very sure
that the flex cables are inserted properly into the flex
sockets before encasing, otherwise faults may occurs.