Related Manuals for Caple PI403
Summary of Contents for Caple PI403
- Page 1 Plaza Island extractor instruction manual PI403 Contact Caple on 0117 938 7420 or for spare parts www.caple.co.uk...
-
Page 2: Table Of Contents
CONTENTS WARNINGS ENVIRONMENTAL PROTECTION USES INSTALLATION REMOTE CONTROL OPERATION MODE TIMING MAINTENANCE Please keep this instruction manual for future reference Instruction manual PI403... -
Page 3: Warnings
Please keep this instruction manual for future reference Instruction manual PI403... - Page 4 - The cooker hood is not intended for outdoor use. - It must only be used as a domestic appliance to extract vapours and remove odours from cooking. Any other Please keep this instruction manual for future reference Instruction manual PI403...
- Page 5 - The cooker hood can get very hot during cooking due to heat rising from the hob. - Do not touch the housing or the grease filters until the cooker hood has cooled down. Please keep this instruction manual for future reference Instruction manual PI403...
- Page 6 2. In its vented version (Fig.2), fumes are directly conveyed outside, through an evacuation duct connected with the superior part of the wall or the ceiling. Both charcoal filter and air deflector are not necessary in this case. Please keep this instruction manual for future reference Instruction manual PI403...
-
Page 7: Environmental Protection
Radio Equipment Directive (RED) 2014/53/EU This Declaration is issued under the sole responsibility of the manufacturer. Hereby, Caple declares that the radio equipment included in the product is in compliance with the RED directive 2014/53/EU. The full text of the EU Declaration of Conformity is available on our website www.caple.co.uk. -
Page 8: Installation
(recommended constant diameter: 150 mm or equal surface area). NOTE: For more information on venting, please see our ‘Extraction & Ventilation guide’ available on our website www.caple.co.uk. Attention: at least two people are needed to perform the installation. Before installing the appliance, in order not to damage the appliance itself, the metal grease filter should be removed. - Page 9 Put down the lower pipe while paying attention it is being properly introduced into the hood. Lift the upper tube (Fig. 7.5) up to the ceiling and insert the two self-tapping screws (Fig. 7.5-D). Please keep this instruction manual for future reference Instruction manual PI403...
- Page 10 WARNING: Before connecting the ducting pipe to the motor, make sure the stop valve, which is on the air outlet of the motor, can swing. Please keep this instruction manual for future reference Instruction manual PI403...
- Page 11 Please keep this instruction manual for future reference Instruction manual PI403...
- Page 12 Please keep this instruction manual for future reference Instruction manual PI403...
-
Page 13: Remote Control
REMOTE CONTROL Remote control used for the operation of Caple island hoods: Technical Data Alkaline battery powered : 12 V mod. 27 A Operating frequency : 433.92 Mhz Combinations : 32.768 Max. consumption : 25 mA Operating temperature: -20 ÷ + 55 °C... -
Page 14: Operation Mode
Press the main power-off button of the hood and then restore power to the electronic control unit. Within the next 15 seconds, press the Light Button to synchronise the central unit with the code. Please keep this instruction manual for future reference Instruction manual PI403... - Page 15 Any adjustments or modifications which have not been expressly approved by the holder of the legal conformity certificate may invalidate the user’s rights relating to the operation of the device. Please keep this instruction manual for future reference Instruction manual PI403...
-
Page 16: Timing
- If the appliance is working at 3rd speed, it is automatically switched to 2nd speed, after 7 minutes operation. Operation speeds can also be changed during operation.The energy consumption of the appliance in standby mode is lower than 0.5W. Please keep this instruction manual for future reference Instruction manual PI403... -
Page 17: Maintenance
- If the supply cord is damaged, it must be replaced by the manufacturer or its sevice agent or a similarly qualified person in order to avoid a hazard. Please keep this instruction manual for future reference Instruction manual PI403... - Page 18 Notes: Please keep this instruction manual for future reference Instruction manual PI403...
- Page 19 Notes: Please keep this instruction manual for future reference Instruction manual PI403...
- Page 20 Caple Service Fourth Way Avonmouth Bristol BS11 8DW t: 0117 938 7420 e: service@caple.co.uk www.caple.co.uk Contact Caple on 0117 938 7420 or for spare parts www.caple.co.uk...
Need help?
Do you have a question about the PI403 and is the answer not in the manual?
Questions and answers