Troubleshooting - Kenmore CROSSOVER MAX Use & Care Manual

RevieZ WKLV WDEOH WR oQG GRLWyourself solutions for minor performance problems. Any service
needed, other than maintenance describeG LQ WKLV 8VH
D TXDOLoed service agent.
WARNING
Disconnect electrical supply before performing maintenance to the vacuum cleaner. Failure
to do so could result in electrical shock or personal injury.
PROBLEM
Vacuum cleaner
won't run.
Poor job of dirt
pick-up.
Agitator does not
turn.
$LUpow restricted
with attachment use;
sound changes.

TROUBLESHOOTING

POSSIBLE CAUSE
1. 8QSOXJJed at wall outlet.
2. Tripped circuit breaker
or blown fuse.
3. Thermal protector tripped.
4. Defective wall outlet.
1. Full or clogged dust cup.
2. WrRQJ pRRU VHWWLQJ.
3. Worn agitator.
Worn or broken Belt.
4.
5. Clogged nozzle, hose, or wand
6. Hole in hose.
 Hose not inserted fully.
Motor protection system
8.
activated.
 DirW\ oOWHUV.
1. Handle in full upright position.
2. Agitator overload protector
tripped .
3. Thermal protector tripped.
4. Nozzle switch in BARE FLOOR
position.
1. Attachment use restricts
DLU pow.
2. New carpet fuzz clogged
air path.
- 23 -
Care Guide, should be performed by
POSSIBLE SOLUTION
1. 3OXJ LQ oUPOy, press the
ON/OFF switch.
2. Reset circuit breaker or
replace fuse.
3. Allow vacuum cleaner to cool
50 minutes (page 12).
4. Check with a good appliance
or lamp. Have outlet properly
serviced.
1. Empty dust cup (page 15).
2. AGMXVW VHWWLQJ SDJH 
3. Replace agitator.
Replace belt (page 20).
4.
5. Check for and remove any
clogs in nozzle, hose, and wand.
6. Replace hose.
 ,nsert hose fully SDJH  
8. Check for clogs in hose.
 &OHDQ SUHoOWHU SDJH   SULPDU\
oOWHU SDJH  RU replace HEPA
MeGLD ([KDXVW oOWHU SDJH  
1. Move handle from upright
position.
2. Press A*,TATOR RESET
button (page 13).
3. Allow vacuum cleaner to cool
50 minutes (page 12).
4. Press nozzle switch to change
WR FDUSHW SRVLWLRQ SDJH 
1. Check attachments for fuzz,
lint, pet hair or other debris.
2. Check for and remove any
clogs and clean hose.