ENGLISH EM6360 – CamLine Pro HD dome outdoor IP camera Table of contents 1.0 Introduction ......................3 1.1 Packing contents ....................4 1.2 Requirements to access the camera..............4 1.3 Major hardware components................4 2.0 Installing the camera ..................... 5 2.1 micro SD-Card installation .................
Congratulations with the purchase of this high-quality Eminent product! This product has undergone extensive testing by Eminent’s technical experts. Should you experience any problems with this product, you are covered by a five-year Eminent warranty. Please keep this manual and the receipt in a safe place.
ENGLISH 1.1 Packing contents The following parts need to be present in the packing: EM6360 Power supply Splitter Cable RJ45 coupler Quick install guide Network cable Mounting material: screws and plugs Window sticker ...
ENGLISH 2.0 Installing the camera A few short and simple steps are necessary to connect and assign the camera, and to enjoy the use of the camera. Use the following steps to connect the camera. 2.1 micro SD-Card installation The video streams can be recorded and be stored onto an internal micro SD-Card. To install the micro SD-Card you will need to open the IP Camera.
Page 6
ENGLISH Then plug the micro SD-card into the micro SD-card slot inside the IP Camera. Note: When you reassemble the camera, please ensure the top and bottom of the dome is closed tightly to be sure the camera will not have a leakage. Note: When you plug in the micro SD-card while the camera is powered, please reboot the camera for the micro SD-card to work properly.
ENGLISH 2.2 Mounting the camera on the ceiling 1. First remove the 3 screws on the base 2. Remove the camera ring from the base. 3. Use the mounting stand to mark the holes at the location where you want to mount the camera (optionally mark a hole for the Ethernet cable as well).
ENGLISH 7. Mount the camera housing to the bracket with the camera base (do not tighten the screws to much so the camera angle can still be adjusted. 8. Connect the power and data cable as described in chapter 2.3.1 2.3.2 9.
ENGLISH ”Power Adapter” Please connect the accessories to the EM6360 correctly, including the power adapter and Ethernet cable. And connect the other end of the Ethernet cable to your network. Usually, this Ethernet cable is plugged into a router or an Ethernet switch. Since the default settings of the EM6360 use DHCP the EM6360 should be connected to the Internet immediately.
10 | ENGLISH Warning: DO NOT connect the splitter cable as illustrated below this will damage your router/modem/switch. 2.4 Installing the CamLine Pro App on an Apple/Android device The EM6360 can be controlled and configured by using the “CamLine Pro” APP. Search for the CamLine Pro APP in the Apple App-store or in the Google Play Store.
11 | ENGLISH 2.5 Installing/removing the camera in the APP on Apple/Android device Open “CamLine Pro”. Select the “+” (A). Select “Add camera”. Choose for option 1 or 2 (B) the option that matches the best with your setup situation and press “Add camera”. Follow the instructions on the screen Press “Add”...
(Windows). Before you can view the video of the camera, you need to install the software ”CamLine Pro”. 1. Download the PC software from our website www.eminent-online.com 2. Unzip the file on your windows PC 3. Click the file setup.exe 4.
13 | ENGLISH 3.0 Viewing images You can view the images both on your computer and on your smartphone screen, as we explain in the sections below. Optionally, you can install the supplied software so you can find the camera directly with your computer and make recordings with your computer.
14 | ENGLISH 4.0 CamLine Pro for iPhone/iPad/Android 4.1 The Layout of CamLine Pro Menu Add camera Android 4.2 Menu of the app Camera list App information...
15 | ENGLISH Android Camera list Installation video App information Exit app 4.3 Overview and control of the camera Portrait view...
Page 16
16 | ENGLISH Landscape view Press the currently displayed stream to get more options Option overview (swipe to the left to view all available options) Mute Record video (locally) Take snapshot (locally) Change video quality Manage camera presets Mirror horizontally Mirror vertically Change the environments frequency Optical zoom + (only available for certain models)
17 | ENGLISH 4.4 Settings of the camera 1. Select a different camera 2. View recordings stored on the SD-card 3. View recordings stored locally 4. Camera settings 5. Remove camera from overview 4.4.1 Select a different camera Using this option you can select a different camera from the camera list to display in the overview.
20 | ENGLISH 4.5.3 Reboot this device 4.6 Advanced settings The settings of the camera are available in the menu option “Advanced settings”. 4.6.1 Camera password Here you can change the password of the camera. Set new password...
21 | ENGLISH 4.6.2 Time zone settings Here you can change the time zone settings and DST (summertime). Select time zone Enable DST (summertime) 4.6.3 WiFi (Not available for EM6360) Here you can set the WiFi settings for your CamLine Pro camera to connect to your WiFi Router/AP.
22 | ENGLISH 4.6.4 Alarm settings Manage the Alarm settings. Enable/disable the motion detector. Select the event after an event has been triggered. Select a Camera preset to point the Change the sensitivity of the camera at after an event. motion detector.
Page 23
23 | ENGLISH Android Configure the phones notification to silent, Set the motion detect sensitivity ringtone, vibrate or Ringtone and vibrate. Select a preset for the camera to Set what the camera should do on an alarm go to if motion is detected. event: send e-mail, save snapshot to FTP server, save video to FTP server...
24 | ENGLISH 4.6.5 FTP settings Set the FTP server settings for the camera to store the snapshots and recordings after an alarm is triggered. FTP server settings...
Set the server settings for your e-mail server for the camera to be able to send an e- mail on an alarm event. Eminent has added popular e-mail servers to the predefined SMTP server list. If you wish to use one of the following email providers you can use the “>” at the server option and select the corresponding mail provider from the list.
26 | ENGLISH The server settings will be entered you still need to enter the displayed sender address, your e-mail user account, password and the recipient e-mail address and press “OK” 4.6.7 SD card settings Set the SD card recording settings, Check the amount of available storage capacity on the SD card and format your SD card.
27 | ENGLISH 6. Start REC: Determine a specific time to start recording to the SD card. 7. End REC: Determine a specific time to stop recording to the SD card. 5.0 CamLine Pro PC software 5.1 The overview of the CamLine Pro PC software 10 11 12 13 14 15 18 19 22 23 24 25 4...
28 | ENGLISH 5.2 Software settings 5.2.1 Software settings Run at startup (Software will start automatically after Windows is started). Use last viewed streams at startup (Show the last viewed streams at startup) Exit to verify identity ...
30 | ENGLISH 5.3.3 Alarm Change the settings and events on an alarm event and press “Apply” FTP settings Set the settings for a FTP server for the camera to be able to save the snapshots or recordings to the FTP server on an alarm event. Example of a FTP server address: ftp.server.com E-mail settings...
31 | ENGLISH 5.3.4 WiFi setting (not available for EM6360) 5.3.5 Date/Time Set the time and time zone or sync the time with your PC. 5.3.6 Device settings Pan/Tilt: Change the settings for the Pan/Tilt feature...
Page 32
32 | ENGLISH Network: Here you can set the network settings of the camera manually.
Page 33
33 | ENGLISH SD card: Set the recording settings for the SD card. Playback recordings on the SD card and format the SD card. The following options are available: Alarm recording: Starts recording if movement is detected Full time recording: Will record continuously No recording: No recording Format SD: The SD card will be formatted (all data and recordings will be deleted from the SD card).
Page 34
34 | ENGLISH ONVIF: Change the Onvif settings (Open Network Video Integration Forum) The ONVIF specification defines a common protocol for the exchange of information between network video devices including automatic device discovery, video streaming and intelligence metadata.
Page 35
35 | ENGLISH Video quality: Change video settings...
36 | ENGLISH 5.4 Playback local recordings Open the Playback feature by pressing the button. In this part you can playback the recordings stored on your PC. 1. First make sure the camera(s) you wish to playback is selected (double click the camera or drag and drop the camera in an available screen).
Page 37
37 | ENGLISH 8. The recording will be played in the selected frame. Playback function bar: 7 8 9 10 11 12 13 14 1. Play 2. Stop 3. Next 4. Stop all 5. Mute 6. Volume 7. Snapshot 8. Clear selection 9.
6. Vertical patrol 6.0 The webpage of the camera The Eminent camera is also an IP camera with its own webpage. This means you can login to the webpage by using the camera’s IP Address. Use the following steps to login to the webpage and change any of the camera settings.
39 | ENGLISH 3. Enter the IP address in the address bar of your web browser followed by : and port number e.g. 192.168.100.101:81 4. Choose the corresponding option matching your internet browser 5. Login with user: admin Password: (leave blank by default) 6.2 The layout of CamLine Pro Change video resolution Settings menu...
40 | ENGLISH 6.3 FTP setting Optionally set your FTP server in this setup menu. Example of a FTP server address: ftp.server.com 6.4 Alarm settings In this setup menu you can you can determine what should happen if an alarm event is triggered.
The latest Frequently asked questions for your product can be found on the support page of your product. Eminent will update these pages frequently to assure you have the most recent information. Visit www.eminent-online.com for more information about your product.
A power socket is needed which should be close and easy accessible from the device. Repairing of the device should be done by qualified Eminent staff. Never try to repair the device yourself. The warranty immediately voids when products have undergone self-repair and/or by misuse.
Eminent products. Eminent products with an internal hard disk have a limited warranty period of two years on the hard disk. Eminent could not be held responsible for any data lost. Please make sure that if the product stores data on a hard drive or other memory source, you will make a copy before you return the product for repair.
Need help?
Do you have a question about the CamLine Pro EM6360 and is the answer not in the manual?
Questions and answers