RAMBO PURSUIT R750P-FF-GY Manual page 12

Next, install the handlebars to the stem using a 4mm Allen wrench. Be sure to tighten the
Allen bolts in a cross pattern when tightening. Tighten to 45 IN-LBS or 5 NM (Make sure the
stem is pointed forward) as shown below.
Then flip the bike upside down so that the bike is resting on the seat and the handlebars. Loosen the axle nuts
from the axle, then put the wheel into the fork making sure the washers are on the outside of the fork on both
sides. As shown below.
12