Installation Procedure; Plug Connection; Package Contents - Sapho EB530 Installation Manual

EB530
ELECTRIC TOWEL HEATER
INSTALLATION MANUAL
Please read the installation instructions carefully before
installation
NOTICE
1. Never use abrasive cleaners, aggressive or caustic agents to clean the body.
Using these agents could damage the surface of the product. Water must not
run down the body surface during operation or cleaning.
2. The maximum load capacity of each of the towel holders is 10 kg.
3. Do not make any technical modifications to the product. Improper
handling can endanger the health or life of the user.
4. If any malfunction is detected, disconnect the product from the power
source and contact your dealer.
5. Before installation, make sure that the body is disconnected from the
power source and the connected cable is without voltage.
6. Only a qualified person may perform the installation.

PACKAGE CONTENTS

installation base
hex key (Allen key)
screws
6
plug
screw with an
internal hexagon
EB530
ELECTRIC TOWEL HEATER
INSTALLATION MANUAL

INSTALLATION PROCEDURE

Plug connection

8 mm
310 mm
STEP 1
Mark the place for drilling a Ø 10 mm
hole.
STEP 3
Tighten with a hex wrench
STEP 2
Fix the bases to the wall with socket
head screws
STEP 4
Hang the body and fasten it to the
bases in the wall. Connect to the mains.