amiad ADI-P Quick Manual

Smartphone operated controller for filtration systems

Hide thumbs Also See for ADI-P:

ADI-P: Smartphone Operated Controller for Filtration Systems

Introduction:

Thank you for purchasing the ADI-P Controller - a smartphone operated controller for filtration

systems. The system consists of two major components, the ADI-P Controller and the ADI-P Mobile

Application.

For a complete guide for using your ADI-P controller please refer to the

download on our website (Download center/Products), or scan the QR code.

This Quick Guide provides the "getting started" instructions for a new filtration system which is

equipped with the integral ADI-P controller.

Important: If your ADI-P controller was supplied as a standalone device for controlling existing filtration systems,

please first refer to the Installing the ADI-P Controller on an Existing Filter chapter in the ADI-P IOM and make sure

to install the controller properly before attempting to operate the system.

Safety First: Before starting, read the Safety Instructions chapter in the ADI-P IOM.

Make sure that you understand and comply with all the relevant safety instructions.

Getting to know the ADI-P Controller:

Single solenoid controller

1. ADI-P panel for manual flushing button and indication LEDs

2. 3-Way 12VDC solenoid #1 – latch

3. 3-Way 12VDC solenoid #2 – latch (dual solenoid only)

4. Solenoids' manual operation handles

5. ADI-P cover

ADI-P

Quick Guide

910101-000990 / 04.2020

ADI-P

IOM, available for

Dual solenoid controller

Page 1 of 4

Table of Contents

Need help?

Do you have a question about the ADI-P and is the answer not in the manual?

Page 1 Important: If your ADI-P controller was supplied as a standalone device for controlling existing filtration systems, please first refer to the Installing the ADI-P Controller on an Existing Filter chapter in the ADI-P IOM and make sure to install the controller properly before attempting to operate the system.
Page 2 Initial operation of the ADI-P Controller: Open the cover of the ADI-P Controller by turning it counterclockwise [1] and insert four alkaline 1.5V AA batteries [2]. The Power LED turns on and the ADI-P Controller starts operating according to its pre-defined default flushing program;...
Page 3 10. In order to view data from your controller, select the active controller from the SITE LIST, marked by the active ® Bluetooth icon. 11. The ONLINE STATUS screen appears and relevant data regarding your filter’s performance can be viewed. ADI-P Quick Guide 910101-000990 / 04.2020 Page 3 of 4...
Page 4 > Download center > Certificates The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Amiad Water Systems is under license. Other trademarks and trade names are those of their respective owners.