Advertisement
Spacer
• Remove paper on spacer and then
attach a spacer (Gray block) on the
back side of refrigerator for better
performance. Make sure a spacer
fix like above image when you install
the refrigerator. It is improving the
refrigerator performance.
(Only for A+++ energy grade models)
• Allow sufficient space to the right, left,
back and top for air circulation.
This will help reduce power
consumption and keep your energy bills
lower.
• Do not install the refrigerator where the
temperature will go below 10 °C.
• Please ensure that appliance can be moved
freely in the event of maintenance & service.
When installing, servicing, or cleaning
behind the refrigerator, be sure to pull
CAUTION
the unit straight out and push back in
straight after finishing.
Also, make sure your floor supports
the full-load refrigerator.
Otherwise, it may cause floor
damage.
Please tie up the extra length of
the power cord at the back of the
CAUTION
refrigerator so as not to be touched
on the floor preventing the power
cord from being crushed by the
rollers upon relocation.
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that has
the same height as the rest of the flooring.
This surface should be strong enough to support
Spacer
a fully loaded refrigerator (or approximately 65
kg).To protect the floor finish, cut a large section
of the cardboard carton and place it under the
refrigerator where you are working.
• Pulling or pushing the refrigerator may
damage the floor.
Moving the refrigerator after installation
may damage the floor.
setting up _17
Advertisement
