How To Set Unit; Setting Of Dip Switch S1 - SanRex CALPOTE UF-1 Series Instruction Manual

HOW TO SET UNIT

Perform a setting of the unit with a good attention in that live parts are exposed when opening a
cover of the unit. Before setting, turn off power.
The standard initial setting of this unit is as listed below. If the unit is used under other conditions, open
a cover on the lower part of the unit to change the setting of dip switch S1 located on the printed circuit.
Control system
Type of temperature control unit
Cycle control

Setting of dip switch S1

Item
Control system
Type of temperature control unit
Cycle control
CAUTION
Phase control
DC4-20mA or DC1-5V
Intermittent type
1 2
ON
OFF
Description
Phase control
Cycle control
DC1-5V/4-20mA
DC0-5V
Two-position control
Not defined
Intermittent type
Continuous type
10
3 4
1
OFF
ON
2 3 4
OFF OFF
OFF ON
ON OFF
ON ON
OFF
ON