Table of Contents
Advertisement
3.5
Ignition Control Setup
The following procedure demonstrates how to remove the backplate of a SEMIL-17XX
series to gain access to the ignition control rotary switch.
1.
Please power off the system and disconnect all cables connected to the system.
Place the system upside-down on a steady surface. Remove the ten (10) screws
indicated, and safe keep for later use. Please separate the backplate from the
system's enclosure.
2.
The ignition control rotary switch can be located on the motherboard, shown below.
SEMIL-1700GC Series
53
Advertisement
Table of Contents
