Preparation; Things To Be Done For Energy; Saving; Initial Use - Beko RDNE510M20B User Manual

Preparation

4
4.1. Things to be done
for energy saving
Connecting the product to electric
A
energy saving systems is risky
as it may cause damage on the
product.
Do not leave the doors of your refrigerator
open for a long time.
Do not put hot food or drinks in your
refrigerator.
Do not overload the refrigerator, cooling
capacity will fall when the air circulation
inside is hindered.
In order to store maximum amount of food
in the freezer compartment, the icematic,
available in the freezer compartment and
easily removable by hand, shall be taken
out. Net volume and energy consumption
values declared on the power data plate
of your refrigerator are measured and
tested by removing the icematic. Do not
remove the shelves inside the freezer
compartment and on the door of freezer
compartment shall not be removed and
they shall always be used they provide
ease of use and efficiency in energy
consumption.
Airflow should not be blocked by placing
foods on the sides of the freezer
compartment fan. A minimum distance
of 3 cm shall be provided on the sides of
protective fan cover.
The baskets/drawers that are provided
with the chill compartment must always
be in use for low energy consumption and
for better storage conditions.
Since hot and humid air will not directly
penetrate into your product when the
doors are not opened, your product will
optimize itself in conditions sufficient
to protect your food. Functions and
components such as compressor, fan,
heater, defrost, lighting, display and so
on will operate according to the needs to
consume minimum energy under these
circumstances.
Food contact with the temperature sensor
in the freezer compartment may increase
energy consumption of the appliance.
Thus any contact with the sensor(s) must
be avoided.
Depending on the features of your
product, thawing frozen food in fridge
compartment will both provide energy
saving and preserve the food quality.
Do not allow contact of the food with the
fridge compartment temperature sensor
shown in the figure below.

4.2. Initial use

Before starting to use your refrigerator,
ensure that all preparations are made
in accordance with the instructions in
sections "Instructions for safety and
environment" and "Installation".
Run the product without putting any
food for 6 hours and do not open its
door unless certainly required.
C
You will hear a noise when the
compressor starts up. The liquids
and gases sealed within the
refrigeration system may also
give rise to noise, even if the
compressor is not running and this
is quite normal.
C
Front edges of the product may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
C
In some models, the instrument
panel automatically turns off
5 minutes after the door has
closed. It will be reactivated when
the door has opened or pressed
on any key.
12 /38 EN
Refrigerator / User Manual