Toyota Matrix 2008 Manual page 141

1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station. (See "TUNE"
"SEEK".) Push and hold down the button
until you hear a beep—this will set the
station to the button. The preset button
number will appear on the display.
To recall a preset station: Push the button
for the station you want. The preset but-
ton number and station frequency will ap-
pear on the display.
These systems can store one AM and two
FM stations for each button. (The display
will show "AM", "FM1" or "FM2" when you
push "AM" or "FM" button.)
(Eject button)
Push the compact disc eject button to
eject a compact disc.
(Reverse/Fast−forward button)
Push and hold " " (preset button 6) or
" " (preset button 5) to fast forward or
reverse within a compact disc. When you
release the button, the compact disc play-
er will resume playing.
'08 MATRIX_U (L/O 0706)
AM
Push the "AM" button to turn on the radio
and select the AM band. "AM" will appear
on the display.
or AUDIO CONTROL (Tone and sound bal-
ance adjustment function)
Each time you push
CONTROL" knob, the mode changes. To
adjust the tone and balance, turn the
knob.
BAS: Adjusts low−pitched tones. The dis-
play ranges from −5 to 5.
TRE: Adjusts high−pitched tones. The dis-
play ranges from −5 to 5.
FAD: Adjusts the sound balance between
the front and rear speakers. The display
ranges from F7 to R7.
BAL: Adjusts the sound balance between
the right and left speakers. The display
ranges from L7 to R7.
DISC (Compact disc)
Push the "DISC" button to play a compact
disc.
When the audio system is set into com-
pact disc operation, the display shows the
track, or track and disc number currently
being played.
Error messages
If the player malfunctions, your audio sys-
tem will display following error messages.
"WAIT": The compact disc player unit
may be too hot. Allow the player to cool
down.
the "AUDIO "ERROR 1": The disc may be dirty, dam-
aged or inserted
down). Clean the disc and re−insert it.
"NO DISC": The compact disc changer of
separate unit is empty. Insert a disc.
"ERROR 3": There is a problem inside
the system. Eject the disc or magazine.
Set the disc or magazine again.
"ERROR 4":
Toyota dealer to inspect.
"CD OPEN": The compact disc changer
lid of separate unit is open. Close the
compact disc changer lid.
If the malfunction still exists, take your
vehicle to your Toyota dealer.
2008 COROLLA MATRIX from Aug. '07 Prod. (OM12B26U)
incorrectly (up−side
Over−current. Ask your
141